Get Latest 300-360 Exam Braindumps

Professionals designed these 300-360 exam questions with extreme care and we assure you will pass the CCNP Wireless certification 300-360 exam by using DumpsSchool exam questions.

Try it Latest DumpsSchool 300-360 Exam dumps. Buy Full File here: https://www.dumpsschool.com/300-360-exam-dumps.html (192 As Dumps)

Download the DumpsSchool 300-360 braindumps from Google Drive: https://drive.google.com/file/d/1te0QnaxUcLu6wS2kfdD-PU5irGe9srzO/view (FREE VERSION!!!)

Question No. 1

An engineer plugs in a Cisco Aironet 2700 Series Access Point and it is running in low power. Which three power requirements should be verified? (Choose three.)

Answer: B, E, F

The access point should be powered by any 802.3at compliant device.

The recommended external power supply for the access point is the Cisco AIR-PWR-B power supply. The access point can also be powered by the following optional external power sources:

— Access point power injector (AIR-PWRINJ4)

— Any 802.3af compliant power injector is supported, but in this case the access point will dynamically shift from 3×4 to 3×3.

Question No. 2

A network engineer is performing a site survey in preparation for an installation. Which three hardware parameters must be inspected? (Choose three.)

Answer: B, E, F

Question No. 3

An engineer would like to calibrate the RF environment to improve accuracy. Which wireless attribute is added to the floor-level calculation by calibrating the floor?

Answer: A

Question No. 4

While performing a Layer 1 passive wireless site survey of a location an engineer detects several instances of low power frequency hopping interference, but cannot physically locate the interfering device or devices. Why is the engineer unable to locate the offending device or devices?

Answer: B

Question No. 5

A network installation on the site with ID 331372269 has been determined to be potentially hazardous to install. Which regulatory body must be consulted to ensure safety during the installation?

Answer: D

Question No. 6

An engineer wants the controller to report when a client exceeds the minimum acceptable RSSI level, to ensure support for the minimum data rate required.

Which controller option must be configured?

Answer: A

If clients on a lightweight access point are detected at threshold levels (RSSI, failed client count, percentage of failed packets, and number of failed packets) lower than those specified in the RRM configuration, the access point sends a “coverage hole” alert to the controller. The alert indicates the existence of an area where clients are continually experiencing poor signal coverage, without having a viable access point to which to roam. The controller discriminates between coverage holes that can and cannot be corrected. For coverage holes that can be corrected, the controller mitigates the coverage hole by increasing the transmit power level for that specific access point. The controller does not mitigate coverage holes caused by clients that are unable to increase their transmit power or are statically set to a power level because increasing their downstream transmit power might increase interference in the

https://www.cisco.com/c/en/us/td/docs/ wireless/controller/7-0/configuration/

guide/c70/c70rrm.html

300-360 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1te0QnaxUcLu6wS2kfdD-PU5irGe9srzO/view

Related Certification: CCNP Wireless dumps